Fluke Biomedical 06-912 - Manual (Page 5)

Introduction
General Description
1
1-1
Section 1
Introduction
1.1 General Description
This self-contained, battery-operated instrument will re-zero any self-reading dosimeter having a standard
charging end. The charger is contained in a two-part case held together by a captive screw. The charging
contact is located in the upper left-hand corner; the voltage control knob is in the upper right-hand corner. The
charging contact contains spring clips (that ensure constant contact) and has a dust cover which is permanently
attached, by a chain, to the case.
1.2 Battery Installation and Instrument Preparation
Loosen the screw on the top of the charger and remove the bottom cover. Insert a standard 1.5V "D"
battery (not included), carefully noting the polarity markings.
A spare bulb, not included, can be stored in the
case.
Replace the cover and tighten the screw. Remove the cap from the charging contact. The charger is now
ready for operation.
NOTE