beautypg.com

Disarming diagnostics – Directed Electronics Model 990 User Manual

Page 40

background image

37

© 2 0 0 6 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d

after that input ceases, the security system will resume normal

monitoring. For example, if your vehicle has an interior light

exit delay and you arm your security system before the interior

light turns off, you may hear a second Bypass Notification chirp.

Once the light turns off, however, the security system resumes

normal monitoring.

disarming diagnostics

Extra chirps that are heard when disarming the system are the

Tamper Alert. If four chirps are heard when disarming the

system, then the security system was triggered in your absence.

If five chirps are heard when disarming the system, a zone was

triggered so many times that the Nuisance Protection Circuitry

has bypassed that zone. In either case, the status LED will indi-

cate which zone was involved (see Table of Zones section). The

security system will retain this information in its memory and

chirp four or five times each time it is disarmed, until the next

time that the ignition is turned on.

note: Bypass Notification does not occur when the sys-
tem is in Silent Mode or if the notification chirps have
been programmed off by the installer.