Flowserve Lockout Module - Manual (Page 2)

Flowserve Corporation 765 South 100 East Phone: 801 373 3028
Flow Control Division Provo, Utah 84606 Facsimile: 801 489 2228
Automation Business Unit www.flowserve.com Email: [email protected]
© 2001, Flowserve Corporation, Provo, UT
Automax Valve Automation Systems
Installation, Operation and Maintenance Instructions
Item Description Material Qty.
1 Lockout Module Al/hard anodized 1
housing
2 Lockout coupler Steel/epoxy powdercoat 1
3 Lockout pin Steel/zinc plate 1
4 Lockout pin cable Steel/nylon coat 1
Bill of Materials
How To Specify
The lockout device shall be an Automax Lockout Module,
capable of being sandwich mounted between an actua-
tor and a standard mounting kit. It shall be capable of
adjustment in one position, and rated for the full load
torque of the actuator specified. The housing shall be
hard anodized aluminum, and the Lockout pin shall be
zinc plated, hardened steel. The Lockout pin shall be
tethered to the Lockout housing and capable of being
safely secured on the unit, when not in use. All materials
of construction shall be corrosion resistant.
Maintenance Instructions
No periodic maintenance is necessary for the Lockout
Module. All parts are designed for the full rated load of
the largest Automax SuperNova Actuator capable of being
mounted to a given Lockout Module. All materials of con-
struction are corrosion resistant, including an aluminum
hard anodized housing.
Options
• Single position - lockout housing is supplied with only
one set of operable lockout slots. Housing may be ori-
ented to provide either lockout open or lockout close.
• Stainless steel hardware - studs, nuts and washers are
stainless steel.
Lockout Single/Dual
Module Position Size Options
LOM Blank - Dual Position 1 - SNA063 SNA085 SNA100 SH - Stainless Steel Hardware
S - Single Position A75 A100 G - Gray Epoxy
2 - SNA115 SNA125 SNA150
A125 A150
3 - SNA175 SNA200 N250
A200 A250
Example: To order dual position Lockout Module for SNA115 with stainless hardware, order LOM2SH.
Note: When ordering Lockout mounting kits or Lockout couplers, specify actuator size and valve size.
Example: To retrofit existing SNA125 mounted to a 3” Durco plug valve, specify LOM2 with Lockout coupler
for SNA125 to 3” Durco G411.
LMR0022-1 (AUTO-19) 01/11 PAGE 2 OF 2
How To Order