Flowserve PlugSeal - Manual (Page 4)

4
INTRODUCTION
The Plugseal valve is a superior plug valve utilizing a
PFA coated plug in a machined body bore to provide
exemplary sealing capabilities in non abrasive services.
Designed for full rated class 600 service conditions with
buttweld ends, the Plugseal valve is designed to ASME
B16.34 and pressures up to 1440 psi. Based on
simplicity, the design allows easy plug removal and
replacement, minimizing the number of spare parts and
inventory required.
SECTION I.
SAFETY PRECAUTIONS
To avoid possible injury to personnel or damage to valve
parts, WARNING and CAUTION notes must be strictly
adhered to. Modifying this product, substituting non-
factory parts, or using maintenance procedures other
than outlined could drastically affect performance, be
hazardous to personnel and equipment, and may void
existing warranties.
1. WARNING: Standard industry safety practices
must be adhered to when working on this, or any
other, process control product. Specifically,
personal protective and lifting devices must be
used as warranted.
2. Depressurize and bleed the line on both sides of
the valve before attempting to service the valve.
3. Check nameplate before installation to ensure that
the valve is not installed in systems where service
conditions exceed those for which the valve was
designed.