Dixon 12881-106 - Manual (Page 46)

CARE AND MAINTENANCE
46
STEERING CONTROL ADJUSTMENTS
(continued):
To adjust steering control levers:
1. Loosen the front and rear bolts retaining the
bellows hold down plate and slide the bellows and
plate up the steering lever to expose the steering
control mechanism.
2. Move the levers inboard to the operating position.
3. Loosen the set screw of the clamp collars which
lock the upper arms to the lower arms.
4. Raise or lower the arms for desired height. There
is approximately 3” of height adjustment available.
Upper shaft should have a minimum of 1-1/2”
engagement in lower shaft.
5. Rotate arms until they have the
desired orientation front to
back.
6. Tighten the clamp collar set
screws.