Flowserve ISC2BB - Manual (Page 6)

4.5 Align the two flats on the
inboard bellows assembly
34A with the two flats on the
inside of the drive ring 10A
in the sleeve end housing,
and press the bellows
assembly into place using
finger pressure only.
(
Figure 8 )
4.6 Place the inboard mating ring
O-ring P1 into the inner
gland 1C . Place the inboard
bellows vibration dampener
M3 into the inner gland.
( Figure 9 )
4.7 Align the two flats on the
inboard mating ring 3C
with the two flats on the
inside of the inner gland, and
press the mating ring in place
using finger pressure only.
(
Figure 10 )
6
Figure 9
Figure 8
34A
Inboard
Bellows
Assembly
Drive Flats 10A
Drive
Ring
O-ring
P1
Vibration
Dampener
M3
Figure 10
3C
Mating
Ring
Drive
Flats