Flowserve ISC1PX - Manual (Page 5)

5
4.6 Place the seat gasket O-ring
13.1 on the O-ring surface
of the stationary face 14 ,
which is the smallest outside
diameter. Place the stationary
face with the sealing face
down on a clean, flat surface.
(Figure 7)
4.7 Align the stationary face drive
pins in stator face support
100
with the drive slots in the
stationary face and press the
stationary face support in
place using finger pressure
only. (Figure 8)
4.8 Install the springs
16 in holes
of stator face support.
4.9 Place the stationary face
and stationary face support
assembly face down onto the
sleeve/rotating face assembly.
(Figure 9)
Figure 7
Figure 8
Figure 9
Seat Gasket
O-ring 13.1
Stationary
Face
14
Align
Drive Pin
with Slot
Face
Support
Spring
Locations
Stationary
Face
14
Stationary Face
and Stationary Face
Support Assembly
Sleeve and Rotating
Face Assembly