1nomenclature, 2disassembly – Flowserve ISC1PX User Manual
Page 2
1
Nomenclature
2
These instructions are written for trained, experienced technicians familiar with the basic
principles and tools involved in the installation, care and service of mechanical seals and
seal support systems. A complete reading of these instructions by personnel in contact
with the equipment is essential to safety. Incorrect installation, operation or maintenance
can result in personal injury or death to personnel and damage to the equipment.
19 183 1
100
24
40 57.1 103
18 76
2
15 14 13.1 13 16
58 57
11
2
Disassembly
Note: Primary seal O-rings (13, 13.1,76) are
all the same size and cross section.
14 Stationary Face
15 Rotating Face
16 Springs
100 Stator Face Support
13 Dynamic (seat gasket)
13.1 Stator (seat gasket)
76 Rotating Face Gasket
18 Gland Gasket
11 Gland Assembly
24 Gland Bushing
103 Setting Device
40 Cap Screw
1 Sleeve Assembly
2 Seal Drive
183 Vibration Dampener
58 Drive Collar
57 Cup Point Set Screw
57.1 Quarter Dog Set Screw
19 Sleeve Gasket
Table 1
Figure 1
When disassembling seal, inspect for conditions which may have caused the
need for the seal to be removed from service. If seal was removed due to
premature failure, determine what conditions caused that failure and correct any
problems prior to returning the repaired seal to service. For assistance with seal
failure analysis, please contact your Flowserve representative.
Seal Parts that are always replaced
• Stationary Face
14
• Rotating Face
15
• Springs
16
• Stator Face Support
100
• All O-rings
13 , 13.1 , 76 , 19
• Gland gasket
18
• Vibration dampener
183
• Setting Devices
103 and cap screws 40
• Cup point and quarter dog set screws
57 and 57.1
• Gland Bushing
24
Reconditionable Seal Parts
• Gland assembly
11
• Sleeve assembly
1
• Drive collar
58
• Seal Drive 2