Fire Magic Gourmet Power Burner Slide-In - Manual (Page 9)

9
INSTALL THE FLAME COLLIMATOR
1. Place the fl ame collimator over the burner with
the tabs and cutouts resting on the inner liner
shelf, as shown in Fig.
9-1 . Flex the front of the
collimator towards the burner until the cut outs fi t
down around the collimator support. This will lock
your collimator into place. The fl ame collimator
acts as a barrier for windy conditions and creates
higher BTU concentration in the cooking grid.
2. When using a wok for stir fry cooking, remove
the grid and the wok will be supported by the
collimator.
REMOVE THE CONTROL PANEL TO CHECK
RATING PLATE
The control panel may be removed to access the
rating plate and check for the gas type of your power
burner.
1. Make sure the burner valves are in the OFF
position. Carefully pull the control knobs from
their stems. Use the Phillips screwdriver to
remove the mounting screws. Make sure to
retain the screws and fi nish washers to reattach
the control panel.
INSTALLING YOUR FIRE MAGIC POWER BURNER (Cont.)
Important: Prior to fully removing the control
panel, you must disconnect the
battery holder assembly wires
that are located behind the control
panel.
3. Carefully lift the control panel away from the
frame.
4. Check the rating plate for gas type.
5. Replace the control panel, being sure to
reconnect the battery holder assembly wires.
Important: Test the electrode for spark before
securing the control panel to the
frame. Place the control panel on
the frame so the front lip of the
control panel covers the lip on the
frame.
6. Secure the control panel to the frame with the
screws and washers. Replace the control
knobs.
ADJUST THE AIR
SHUTTERS
Power burner air shutter(s)
are located on the necks
of the power burner as
shown in Fig. 9-2.
CAUTION: DO NOT handle a hot burner without
adequate hand protection.
To adjust the air shutters:
1. See step 2 under the CHECK FUEL ORIFICES
FOR PROPER SIZE section.
2. Lift the back of the burner upward so that the
burner stud in the bottom back clears the
locator hole in the burner rest.
3. Move the burner back away from the front of the
power burner while continuing to lift the back
upward so that it clears the rear fi rewall.
4. Turn the shutter to the desired opening size
and replace the burner to test the effect on the
fl ame (see LIGHTING INSTRUCTIONS).
Burner flames should burn evenly (mostly
blue). A proper fl ame pattern will ensure safe
operation and optimal performance.
Fig. 9-2
Air shutters
Fig. 9-1 Placing the fl ame collimator
Flame
collimator
Collimator support
Tabs
Cut
outs