Fire Magic Charcoal Patio Post Barbecue 22 Series - Manual (Page 4)

4
Simple to use, this elegant stainless-steel charcoal
grill has the added benefi t of an adjustable charcoal
pan to allow you to change the height of the charcoal
while cooking, and gives you the ability to add fuel
without having to remove the cooking grids. This
enables the outdoor chef to be in complete control
of the cooking heat at the grilling surface.
USING YOUR CHARCOAL GRILL
1. Remove the cooking grids and pile your charcoal
on the charcoal pan(s). Avoid spillage.
WARNING: When adding charcoal, spread it
across the charcoal pan evenly and DO
NOT exceed a height of 1" above the
charcoal pan.
Excessive amounts of charcoal may
cause over heating and damage to
your grill.
Note: You may lift the edge of the shelf upward
to gain better access during much of the
tightening of this screw.
4. Finally, insert the bottom screws on the left and
right side of the shelf and securely tighten all
screws.
Detaching is the reverse process of above.
This grill comes with two (2) rigid shelves that must
be attached. These can be attached using the four
(4) support screws provided and a long Phillips-head
screwdriver.
1. Hold the shelf inverted so that one of the corner
holes in the shelf lines up with the appropriate
upper screw hole in the grill.
2. Insert the screw (but do not tighten all the way)
so that the shelf can be easily rotated around
the fi rst screw.
3. Line up the second corner hole in the shelf with
the remaining upper screw hole in the grill. Insert
a screw and tighten.
Shelf support screws
Fig. 4-3 View from under right shelf
RIGID SHELF ASSEMBLY
OPERATION
2. Follow the instructions supplied with your
charcoal/fuel for lighting.
3. Use the access door to add or spread out your
coals while cooking.
CAUTION: Use long-handled insulated barbecuing
tools to prevent burns from hot metal
or coals.
4. Turning the crank handle raises or lowers the
pan to increase or decrease the grilling heat as
you desire.
REV 4 - 1405300810 L-C2-214
INSTALLATION & SETUP (cont.)
ASSEMBLY
1. Locate the crank handle (Fig. 4-1) packed inside the grill
enclosure.
2. Open the door in the front panel as shown in Fig. 4-1 and
insert the threaded end into the crank handle through the
hole on the right of the grill face and into the nut on the frame
as shown.
3. Center the crank on the nut and begin cranking in a clockwise
direction until the threads have properly caught hold.
4. Close the door in the front panel and continue cranking until
the lifter begins to move upward inside the grill.
Note: The access door must be closed for the crank to raise
the lifter to the highest position.
5. Place both cooking grids with cut-outs toward the front as
shown in Fig. 4-2.
ALIGN CRANK HANDLE
WITH NUT & SCREW IN
Fig. 4-1
Crank
Door
Fig. 4-2