Dodge 2010 Challenger User Manual

Page 343

• Always start the engine before turning ON the TIRE-

FIT kit.

NOTE:

Manual transmission vehicles must have the

parking brake engaged and the shifter in NEUTRAL.

• After pressing the Power Button (3), the sealant (white

fluid) will flow from the Sealant Bottle (1) through the
Sealant Hose (7) and into the tire.

NOTE:

Sealant may leak out through the puncture in

the tire.

If the sealant (white fluid) does not flow

within 0 –

10 seconds through the clear Sealant Hose (7):

1. Press the Power Button (3) to turn OFF the TIREFIT
kit. Disconnect the Clear Sealant Hose (7) from the valve
stem. Make sure the valve stem is free of debris. Recon-
nect the Clear Sealant Hose (7) to the valve stem. Check
that mode select knob (4) is on sealant mode position and
not air mode. Press the Power Button (3) to turn ON the
TIREFIT kit.

2. Connect the Power Plug (5) to a different 12 Volt
power outlet in your vehicle or another vehicle, if avail-
able. Make sure the engine is running before turning ON
the TIREFIT kit.

3. The Sealant Bottle (1) may be empty due to previous
use. Call for assistance.

NOTE:

If mode select knob (4) is on air mode and pump

is operating, air will dispense from black air pump hose
(6) only, not the clear sealant hose (7).

342

WHAT TO DO IN EMERGENCIES