FiberPlex TD-DINR - Manual (Page 6)

Mounting the TD Module
Mount the TD unit in the same manner regardless of the initial configuration of the mount itself or
the height of top hat DIN rail utilized (35 x 7.5 or 35 x 15mm). The edge mounting solution
happens to be shown below. All fasteners necessary for configuration and mounting are included.
1) Line up key hole on the bottom of the TD Module with the studs on the Mounting
Bracket and push flat against the plate.
2) Slide the TD module forward until it stops.
3) Tighten the Retaining Screw until snug.
4) Snap the Rail Clips on to the DIN Rail.