FiberPlex TD-DINR - Manual (Page 3)

Introduction
The FiberPlex TD‐DINR is a specialized Mounting Bracket intended to mount a single FiberPlex TD‐
Series unit onto DIN rail conforming to standard EN 50022 (top hat sections only). Either 35 x
7.5mm or 35 x 15mm section DIN rail will be compatible with this device.
Possible mounting configurations are:

Flat mounting, the lower profile but wider rail signature
Or

Edge mounting, the higher profile but narrower rail signature
Key Features

Tool‐less DIN rail attach/detach

Tool‐less TD unit mount/dismount

Mounting configuration requires no alteration of the chassis

Provision is made for cooling airflow
Getting Started
Initial Inspection
Immediately upon receipt, inspect the shipping container for damage. The container should be
retained until the shipment has been checked for completeness and the equipment has been
checked mechanically and electrically. If the shipment is incomplete, if there is mechanical
damage, or if the unit fails to operate notify FiberPlex and make the shipping materials available
for the carrier's inspection.