DirecTV HD DVR User Manual

Page 60

Running the System Test

The System Test allows you to run a basic diagnostics check on your DIRECTV Plus HD DVR. If you are experiencing
any trouble with your receiver, run the system test. It will also allow you to get your access card and receiver ID num-
bers or to initiate diagnostic procedures on your digital satellite receiver.

First make sure that:

All

connections — jacks, cables, etc. — are in place correctly (see Chapter Two, Getting Connected, for more

information)

There are

batteries in the remote control, and they are working correctly

The access card is installed in the DIRECTV Plus HD DVR.

Follow these steps to run the diagnostics system test on your DIRECTV Plus HD DVR.

1) Turn on your TV and the DIRECTV Plus HD DVR.

2) Slide the mode switch to the DIRECTV position to put the remote control in satellite receiver-controlling mode, then

press MENU to display the Quick Menu.

3) Select

Settings.

4) Select Setup, then Info & Test.

5) Highlight the System Test tab and press SELECT, then press SELECT on Run Test.

6) If your system does not pass the system test, check any of these potential trouble areas: cabling, pointing the satellite

dish, phone connection and access card.

7) If you continue to have problems, call DIRECTV Customer Service at 1-800-DIRECTV.

You should run a system test several times before concluding that there is a problem. Occasional fluctuations in the
phone line or satellite signal can give temporary false readings.

HR21 Book.indb 49

7/31/07 2:36:15 PM