EXCALIBUR PR640 RC Motorized Drink Float - Manual (Page 4)

To begin, insert the
antenna wire through the
hollow tube. Avoid pulling
the wire too tight. The wire
is on the top of your
Motorized Drink Float. Tie
a knot on top to secure.
Turn the switch to the
ON
position for power.
In a clockwise direction,
screw the antenna into the
cavity located at the top of
the transmitter.
Use the control switches
on the transmitter to drive
your Motorized Drink
Float. It will allow you to
drive it forward, reverse,
left and right.
Use both control switch-
es to turn. If you want to
turn right while driving for-
ward, switch the right
switch right and switch the
left switch up. If you want
to turn left while driving in
reverse, switch the right
switch left and switch the
left switch back.
Tips
• If it does not respond to
the transmitter, move closer
to your Motorized Pool
Float and try again.
• If it starts to lose power,
it may experience loss of
performance. If this hap-
pens, simply replace with
new batteries.
• If it moves slowly, try
changing the batteries and
check the wheel mecha-
nisms for lint, thread, hair
or dust.
• When the transmitter
range decreases, replace the
battery in the controller. If
someone uses a CB nearby,
it might interfere with con-
trol of the Motorized Drink
Float. If this happens, move
it and transmitter away from
the CB.
6 7
How to Use
To install batteries in the transmitter, please
follow the following steps:
1. Remove battery cover located at the back.
2. Insert one 9-volt battery following the
+/- marking.
3. Replace battery cover.
To install the power pack in your Motorized Drink Float,
please follow the following steps:
1. Carefully twist off the center bowl in a clockwise direction.
2. Unlock the battery compartment door by it pulling up.
3. Insert six D-cell batteries (not included) in the battery compart-
ment, making sure to match the polarity (+ and -) with the diagram
inside the battery compartment.
4. Lock the battery door by pressing it down. You should hear a
click when it is secure.
5. Carefully twist the bowl counter-clockwise back in its original
position.
(Also see Battery
Information on page 8)
Installing Batteries