Ethereal TL64 - Manual (Page 4)

Assembly Instructions
Step 1:
Read and understand all of the directions. Use only as according to
the directions.
Step 2:
Mount the wall plate (A) on the wall
Wood Stud Mounting:
The Wall Plate must be mounted to the center point of two wood studs that are
at least 16 inches apart. The minimum width of these wood studs should be at
least 1.5” (standard US 2” x 4”).
Find the stud locations then hold the wall mount bracket against the wall.
While using a level to verify that the wall mount bracket is correct, mark the
bolt hole locations that coincide with the studs.
Using a 7/32 drill bit Pre-drill a 2.5” deep hole in each marked location.
Attach the Wall Plate to the wall using the supplied lags and washers. Please
make sure that the lags have been tightened and are secure.
Attach the vertical arms (B) to the back of your display (securely).
Hang the display on the top rail of the wall mount bracket (C).
Before seating the mount into the lower rail of the wall mount bracket connect
and route all of the connecting cables and power cord.
3
(A)