ETA Eddie User Manual

Page 21

4) Carefully insert the tip into outer ear canal.

CAUTION: Do not insert the tip further

than 5 mm into the ear as this could causedamage to the eardrum.

5) Turn off Clipper. Wipe attachment clean after each use.

Trimming Eyebrow

1) Nose, ear and eyebrow attachment should be on Clipper

2) Switch the Clipper on and use the tip to cut individual eyebrow hairs.

3) The Clipper can be used for clipping single long hairs.

4) Put the Clipper at the root of the hair and move it along the edge of the eyebrow

from the base of the nose towards the outer tip of the eyebrow in the direction of hair

growth.

IMPORTANT: Do not use the Clipper to define or trim the entire eyebrow. Do not try to

trim your eyelashes. Be careful not to get too close to your eyelashes and eyes!

5) Turn off Clipper. Wipe attachment clean after each use.

Shaving With Micro Shaver Attachment

1) Put the micro shaver attachment on the clipper.

2) Use the narrow micro shaver to shave along contoured edges to remove any stubble

while creating a smooth welldefined beard line. Before using the micro shaver, always

check it for wear and damage. If the micro shaver shows signs of wear or damage, do

not use it as injury may occur. Do not use the micro shaver until it has been replaced.

Gently press the micro shaver onto the skin. Do not press too hard.

Trimming facial hair

1. Wet facial hair slightly and brush it before trimming.

2. Mark a facial hair line with the trimmer and cut off the hairs exceeding this line from the

outer perimeter

3. If you want to achieve an even trim of facial hair, use one of the attachments (6) or trim

carefully the ends by small pieces over the brush in such a way that the brush moves

through the hair upwards. Repeat the process in the whole facial hair area.

4. After trimming shave the parts around the beard in a usual way.

Trimming a mustache

1. Wet mustache slightly and brush it before trimming.

2. Trim carefully over a brush to achieve an even cut of the mustache.

If you prefer using your finger as a guide, proceed accordingly.

IV. MAINTENANCE

Turn off the appliance before each maintenance, or unplug the adapter from the

electric socket! Do not use rough and aggressive detergents! Wipe the trimmer

surface with a wet soft cloth.

Cleaning blades

Clean the blades with an enclosed brush. If the blades are very soiled, you can remove

the whole trimming head from the trimmer (figure 5) and clean it in running water. Also

clean the area below the removed trimming head. After drying, put the head with the

blades back to the trimmer in the opposite way (you will hear a clicking sound).

In order to keep the trimmer in a perfect condition, you have to lubricate the list with

/ 36