ETA Eddie - Manual (Page 20)

Clipping with hair comb attachment
1) Put the hair clipper comb on the full width trimmer attachment and push until you
hearit ‚click‘ into place.
2) Press the Hair Length Selector and slide it to the desired setting.
3) When you are clipping for the first time start at the maximum clipping length setting
to familiarize yourself with the clipper and prevent accidentally trimming hairs too
short. As you become familiar with the settings, adjust the Hair Length Selector to
desired trimming length. Selector will ‚click‘ into position at each setting.
4) Make sure that the flat part of the comb is always in full contact with the scalp to
obtain an even result.
5) Move the clipper slowly over the crown from different directions to achieve an even
result.
6) Always move the clipper against the direction of hair growth.
7) Make overlapping passes over the head to ensure that all hair that should be cut has
been cut.
8) Turn the Clipper off and remove the hair comb often to blow and/or shake out hair that
has accumulated.
Contouring without the hair clipping comb attachment
1) Remove the hair comb. Be careful when you are clipping without comb attachment as
when the clipper is turned on it will trim every hair it touches.
2) Tilt the clipper in such a way that only one edge of the trimming attachment touches
the hair ends when you shape the contours around the ears.
3) To contour the nape of the neck or hairline, turn the clipper and hold it with the
trimming attachment pointing downwards.
4) To contour the sideburns, turn the clipper and hold it with the trimming attachment
pointing downwards.
Trimming
- Make sure hair is clean and dry.
- Always comb the hair with the styling comb in the direction of growth before you start
trimming.
- Do not move the Clipper too fast. Make smooth and gentle movements.
Trimming Nose Hair
1) Make sure nasal passages are clean.
2) Place nose, ear and eyebrow attachment on Clipper.
3) Switch the Clipper on and insert the tip of the attachment into one nostril.
CAUTION: Do Not insert the tip more than 5mm into your nostril.
4) Slowly move the tip in and out while turning it around at the same time in order to
remove unwanted hair. For best results, make sure the side of the tip is firm against
skin. This will reduce the tickling effect that can occur during trimming of nose hair.
5) Turn off Clipper. Wipe attachment clean after each use.
Trimming Ear Hair
1) Clean outer area of ear and ear canal. Make sure it is free of wax.
2) Nose, ear and eyebrow attachment should be on the Clipper.
3) Switch the Clipper on and move the tip softly around the edge of ear to remove hairs
extending beyond the outer ear.
20
GB
/ 36