ETA Ultimo - Manual (Page 17)

ingredient recommended slice thickness of the cut food.
pastry, bread 10 mm
cheese, smoked goods (soft salami) 3 mm (wet the knife with cheese so that the
slices do not stick)
smoked goods (ham, flitch) 2 mm
smoked goods (dry-hard salami. 1 mm
Set a desired thickness of cut slices by turning regulator B1. Place the food on the feeding
device B6 and push it fluently to the cutting knife with the holder B7. Pressing both the
switch and the safety switch A1, A2, the cutter will turn on. The cut slices fall on the tray
B9 placed next to the cutter. If you want to interrupt or stop cutting, release the A1 and A2
switches.
Note
Maximum time of operation is 6 minutes, then leave the appliance rest and cool down for
approx. 30 min. If the propulsion unit is overloaded, there might be vibrations in the cutter.
In such case, turn the cutter off and keep a break approx. 15 min. necessary for cooling
down the propulsion unit.
V. MAINTENANCE
Before any handling of the appliance pull out the fork of the supply cord A4 from the el.
outlet. Do not use rough and abrasive cleaning agents (e.g. sharp objects, scrapers,
diluents or other dissolvents)! You may remove the propulsion unit A, knife B3 and
board for slices thickness setting B4 for easier cleaning.
Pushing the A3 button you will release the arrest of the propulsion unit in the cutter and
you will then remove it by its folding out (pic. 3). Clean the propulsion unit A with a damp
cloth and soap. Remove the slice thickness setting board from the cutter by turning the
regulator B1 until the board B4 is unscrewed. Clean all accessories immediately after use
in hot water with soap (you can use a dish washer). Hold the knife by the plastic holder
in its centre and release it by turning it clockwise all the way. Then lightly slide the knife
out from the cutter (pic. 4). Be very careful when cleaning the knife! Pay attention that
the cutting edges of the accessories do not come in contact with hard objects which blunt
them and thus decrease their efficiency. Some foods may discolour the accessory. This
has, however, no effect on the functions of the appliance and this discoloration will usually
disappear with time. Never dry the plastic die-cast over a heat source (e.g. stove, el./gas
cooker). After cleaning, store the appliance in a dry, dustless, safe place, out of reach of
children and persons sui juris.
VI. ENVIRONMENTAL PROTECTION
If the dimensions allow, there are labels of materials used for production of packing,
components and accessories as well as their recycling on all parts. The symbols specified
on the product or in the accompanying documentation mean that the used electrical or
electronic products must not be disposed of together with municipal waste. For proper
disposal of the product, hand it over at special collection places where it will be received
free of charge. Suitable disposal of the product can help to maintain valuable natural
resources and to prevent possible negative impacts on the environment and human health,
which could be the possible consequences of improper waste disposal. Ask for more
details at the local authorities or at a collection site. Fines can be imposed for improper
disposal of this type of waste in agreement with the national regulations. If the appliance is
to be put out of operation, after disconnecting from power supply we recommend its cutoff
and in this way it will not be possible to use the appliance again.
17
GB