ETA Ultimo User Manual

Page 16

— Use this appliance only for its intended purpose described in these instructions for use!

— Never use the appliance for any other purpose!

— The producer does not undertake any responsibility for damage or injuries caused by

improper use of the appliance and the accessories (e.g.

food deterioration, injuries,

cuts) and its guarantee does not cover the appliance in the case of failure to comply

with the safety warnings above.

II. Features of the device (pic. 1, 2)

A – propulsion unit

A1 – switch

A3 – propulsion unit arrest button

A2 – safety switch

A4 – supply cord

B – cutter

B5 – guiding board

B1 – strip thickness setting

B6 – food feeding device

B2 – strip thickness indicator

B7 – food holder with a hand rest

B3 – cutting knife

B8 – thumb protectors

B4 – board for setting the slice setting

B9 – tray

III. PREPARATION FOR USE

Remove all packaging material, remove the accessory. Remove all adhesive foils, stickers

or paper from the appliance. Wash the parts which will come in contact with the food in hot

water with soap before first use. If you want to cut bigger amounts of food, you may use

the tray in the bottom part of the guiding board for storing away cut food. Place the cutter

on a dry place on a table or kitchen desk with good surface adhesion.

Assembling the cutter (B5, B6, B7, B8)

Insert the thumb protector

B8 into the opening in the feeding device B6 and secure by

pushing lightly (an audible clap will sound). Both parts will remain attached. Fold down the

guiding board

B5 and slide the feeding device B6 on the board so that the protrusion on

the bottom part of the feeding device fits into the protrusion in the guiding groove of the

board (see pic. 5). The feeding device must move on the guiding board lightly. Then slide

the food holder

B7 on the feeding device from the side. When using the cutter correctly,

the food holder serves as a hand rest and thumb protector.

Slices thickness regulator (B1)

Set a desired thickness of the slice in a range of 0 - 15 mm by turning the

B1 disc. The

thickness of the slice is marked on the

B2 scale.

Switch and safety switch (A1, A2)

For putting the cutter into operation, it is necessary to press both the switches

A1, A2.

First press the

A1 switch (hold it down) and then press the safety switch A2. Releasing the

switches, the cutter will turn off automatically.
IV. USING THE CUTTER

Consider these following tips for processing examples and inspiration whose purpose

is not to provide a manual but to show ways of different food processing. The cutter is

designed for cutting bread, pastry, smoked goods, meat, cheese, vegetable and fruit. From

time to time, we recommend pausing the operation, turning the appliance off and removing

parts of ingredients which have stuck on the knife or the dish (see par.

I. SAFETY

PRECAUTIONS).