ETA Tradiční suchá žehlička 7246 - Manual (Page 12)

– After finishing work and before cleaning, always switch off the appliance and disconnect it
from power supply by taking the power cord connector out of the electric socket.
– Prevent loose hanging of the supply cable over the edge of the worktop where children
could access it.
– Do not place the iron in such a way that could represent harm (e.g. fire, burn and scalding).
– When putting the iron on a stand, make sure that the surface, on which the stand is
placed, is stable.
– Never iron clothes on people.
– When switching the iron for the first time, set the highest temperature and leave the iron
on for at least 10 minutes without water. There can be light fume coming out of the
iron which is cause by burning of the used lubricants and binding agents in the steam
chamber.
– Make sure that the power cord is always dry and it is not damaged.
– Check the condition of the power cord of the appliance regularly.
– Avoid free hanging of the power cord over edge of a worktop so that the power cord is
accessible to children.
– The power cord must not be damaged with sharp or hot objects, open fire and it must not
be sunk into water.
– Iron and its supply keep out of reach of children under 8 years (when is plugged in to
power or cools down).
– If you need to use the extension cord, it has to be uncorrupted and it has to comply with
the valid standards.
– Never use the appliance for any other purpose than for the intended purpose described in
these instructions for use! Iron is not intended for use in places with explosive danger.
– The producer is not responsible for damage caused by improper use of the appliance
(e. g. burning, scalding, fire, clothes damage, scratching, ironing plate
contamination) and its guarantee for the appliance does not apply to situations when the
safety warnings above are not complied with.
II. DESCRIPTION OF THE APPLIANCE (fig. 1)
A1 – ironing board A4 – storage board
A2 – control light A5 – space for power cord wind-up
A3 – thermostat regulation wheel A6 – power cord
III. INSTRUCTIONS FOR USE
Remove all the packing material and take out the iron with the accessories. Remove
possible labels, protective foils or covers before the first use.
Ironing temperatures
– Sort laundry and iron according to the instructions for treatment
(e.g. manufacturer‘s recommendation – a label on clothes). If the instruction is missing
and you know the material of the clothes, follow the table on picture 3. The table applies
only to materials only, not to possible decorations, material treatment, etc.
– Start to iron from the lowest temperatures to higher temperatures. If clothes consist of
e.g. two and more materials or if it is treated by stringing, purls, relief, always iron
according to the material with the lower temperature only. If you do not know the material,
find the suitable place that is not visible when wearing and try suitable temperature for
ironing at the place.
– When ironing woollen fabrics, we recommend ironing on the back side of the fabric and
you can iron virgin wool through additional cloth. Velvet and similar fabrics can be ironed
in one direction ( you will prevent creation of glossy areas).
12
GB
/ 26