ETA Carsha - Manual (Page 21)

CAUTION
– If you charge the battery for the first time or after long storage, about 60 % of its
total capacity is charged. After repeated discharge and repeated recharge the battery
is charged to 100 %.
– After completing hard work or in hot environment, the battery may be too hot for
charging. Let the battery cool down before charging.
– For ensuring longer life of the battery we recommend full discharge and then full
recharge of the battery four times a year.
– Maximum charging time is 15 hours, do not exceed this time!
!
IV. USING THE VACUUM CLEANER
According to the selected cleaning activity, use the vacuum cleaner and select the
corresponding accessories ( C, C1).You can use crevice nozzle C for vacuuming places
that are hard to access. Crevice nozzle with the brush C1 on can be used to clean various
types of furniture (Fig. 6). You can switch the vacuum cleaner on and off by push A1.
Let the vacuum cleaner recharge as soon as its suction performance gets weaker.
Emptying dust container
If you find out that the suction performance of the vacuum cleaner is reduced, make sure
that the dust container is not full and if necessary, empty it. Release locking of container
B by pressing buttons B4 it from the vacuum cleaner by tilting (Fig. 7). Pull out holder B3,
HEPA-filter B1 and filter protector B2 from the container (Fig. 8), then place the container
over a dustbin and empty it into common municipal waste (Fig. 9). For sanitary reasons we
recommend emptying the container outside housing premises.
Cleaning dust container and cleaning filter
After the container has been emptied about 5 times we recommend complete cleaning
of the suction system from the settled dust. Clean all parts (i.e. the container, holder,
the HEPA filter, the filter protector unit can be cleaned by tilting off the dust container).
Tap the dust out of the filter over a dustbin or to clean the filter through a blowing (we
recommend the filter cleaning outside of living area for hygiene reasons), (Fig. 11). If the
protection micro filter is very dirty, you can also rinse the pleated side of the HEPA filter
under lukewarm slow-running tap. Hold the filter in such a way that the pleated side points
upwards and the water flows parallel to the pleats. Hold the filter at an angle so that the
water washes away the dirt inside the pleats. Turn the filter 180° and let the water flow
along the pleats in the opposite direction. (Fig. 10). Continue this process until the filter is
lid. After drying, insert the cartridge back to the dust container in the opposite way.
21
GB
/ 37