ETA Profi User Manual
Page 15

15/ 35
– Never immerse the vacuum cleaner into water (even its parts)!
– The operating position of the appliance is horizontal and it is not allowed to stand
the cleaner up, tilt it or turn it over during operation! Do not pull on the hose and
avoid rough handling of the cleaner!
– Never vacuum without a properly inserted filtration system and micro–filters.
– Before you start using the vacuum cleaner, please check that all the blocking mechanisms
are in the right position.
– Do not vacuum wet or moist floor coverings, do not use the vacuum cleaner for outdoor
areas! When moisture gets into the aggregate, there is a risk of its damage and disabling
it. This defect is not covered by the warranty.
– Vacuum cleaning of some carpet types may result in generating static electricity.
No static electricity discharge is dangerous to health.
– Never leave the vacuum cleaner exposed to weather conditions (
rain, frost, direct sun
radiation, etc.).
– Do not vacuum sharp objects (e.g.
glass, shatter), hot, flammable, explosive items
(e.g.
ash, hot cigarette butts, gasoline, thinners and aerosol vapours) or greases
(e.g.
fats, oils), caustic agents (e.g. acids, solvents). Vacuuming these objects may lead
to damage of the dust filters, or the vacuum cleaner.
– Do not insert fingers or other things to input and output vents of the appliance. If the openings/
elements for air flow are clogged (e.g. the hose), turn the appliance off and clear the clogging.
– Pores of the dust filter may be clogged when vacuum cleaning very fine dust. Thus, air
permeability will be reduced and the suction performance will decrease. In this case the
dust filter must be changed and clean micro–filters, even if the dust filter is not full yet.
Do not use the vacuum cleaner to vacuum dirt produced during/after construction such as
plasterboard dust, fine sand, cement, dust from construction, parts of plaster etc.
If this dirt / loose construction materials / loose construction materials into the aggregate,
it poses a danger of damage. The warranty repair does not cover this.
– The vacuum cleaner is not suitable for vacuuming substances that can harm human health.
– Do not use the appliance in an environment saturated with explosive or flammable steams.
– The power cord is marked with colour codes. The yellow strip indicates the ideal cord
length, the red strip indicates the maximum cord length. Do not apply force to unwind the
cord beyond the red mark.
– Do not run over the power supply cord when using the vacuum cleaner and do not unplug
it from the socket by pulling the power cord.
– When taking the plug from the electric socket, never pull the power cord or the vacuum
cleaner.When winding the cord, hold the plug to prevent the cord lashing around and
to prevent possible injury.
– The power cord must not be damaged with sharp or hot objects, open fire, it must not be
sunk into water or bent over sharp edges.
– If you need to use an extension cord, it has to be uncorrupted and it has to comply with
the valid standards.
– In order to ensure safety and proper function of the appliance, use only original spare parts
and accessories approved by the manufacturer. Never use the appliance for any other
purpose than for the intended purpose described in these instructions for use!
– The manufacturer is not responsible for damage caused by improper use of the appliance
and the accessories and its guarantee for the appliance does not apply in situations when
the safety warnings above are not complied with. Failure to replace or maintain all filters
regularly according to the instructions in Chapter
III. USING VACUUM CLEANER and
also using non–original filters, the properties of which resulted in failure or damage of the
vacuum cleaner is also understood to be improper use of the appliance.
GB