Dolby Laboratories Flat Panel Television - Manual (Page 20)

Chapter Installing the LCD TV

METHOD A:
Use a supplied antenna cable to connect the NTSC signal to the LCD TV’s TV CABLE
terminal.
METHOD B:
Use a supplied antenna cable to connect the ATSC signal to the LCD TV’s
HDTV AIR terminal.

Connect the AC power cord at the back of the TV and connect the power cord to wall
outlet.

Press the button on the remote to turn on the LCD TV.
Always disconnect the LCD TV from the main voltage when the LCD TV will
not be used for a long period of time. The POWER button on the front panel
is only used for switching the LCD TV into standby, it does not disconnect
the device from the main voltage. To completely disconnect the main
voltage, please remove the power plug from the socket.

Press the Input button on the remote to
display the Input List. Use the ▲► buttons to
select TV( METHOD A), or HDTV (METHOD
B), and press the OK button.
TV
CABLE
HDTV
AIR
VHF/UHF IN
A
B
TV
CABLE
HDTV
AIR
VHF/UHF IN
Main
TV(CABLE/AIR) 
HDTV (CABLE/AIR)
VIDEO (SIDE)
VIDEO (REAR)
VIDEO (S-VIDEO)
VIDEO (YPbPr)
VIDEO (YPbPr)
VIDEO (HDMI)
COMPUTER (VGA)