Entone Hydra HD A-Series - Manual (Page 4)

COPYRIGHT     2007 ENTONE, INC. ALL RIGHTS RESERVED .
Hydra HD Quick Reference (P/N 88-4300) 4
7. Programming Remotes For Use With Hydra
First, you must program your remotes for use with your Hydra. The Hydra comes with 3 URC remotes.
Each remote can be programmed for use with a different TV/Room. (Refer to the Hydra HD User’s
Guide for more information on in-home configurations.)
Press and hold the “OK” button on the Hydra front panel for approx. 5 seconds. When releasing the
“OK” button, the Hydra front panel will display “RC REG”. The Hydra is now in remote registration
mode.
Identify the remote control, which is labeled with a number 1, 2, or 3 on the battery cover plate on
the bottom of the remote, as shown below:
Press and hold the “STB” button on the remote control for about 4 to 5 seconds. The “STB” button
backlight LED will light to indicate that the remote control is in registration mode.
Use the number keys to send the registration event:
• Press “1” to send the “Register remote control to Decoder 1” event for Remote #1.
• Press “2” to send the “Register remote control to Decoder 2” event for Remote #2.
• Press “3” to send the “Register remote control to Decoder 3” event for Remote #3.
• Press “0” to set remote control to IR mode only. The remote control will not send any RF
signal.
If you press a key other than "0", "1", "2" or "3", or if you do not press a button within about 10
seconds, the STB button backlight LED will turn off, and the remote control registration process
terminates.