Entone Amulet 300 (F1) - Manual (Page 6)

URC 4 User’s Guide
Copyright     2012 Entone, Inc. All rights reserved . 5
v2.5 for URC 4
Chapter
2
2.1 Controlling STB using RF URC
Janus is a multi-television media hub. It can support multiple outputs in multiple rooms viewing different
channels or TV programs. Amulet is a single output video receiver. You can connect Amulet to a primary
output only.
You can use RF URC 4 to control Janus/Amulet using radio signals (RF). These radio signals travel over
long distances and go though walls and other solid objects. You must connect the Remote Antenna
Package (RAP) to the rear panel of the Janus/Amulet.
Your Janus/Amulet comes with one IR URC 4 to be used for output 1 (primary). (Additional RF URC 4 can
be purchased separately.) Your RF URC 4 must be registered to one of the 2 outputs (primary or
secondary) before it can be used. One RF URC 4 can only be registered to one output. However, you can
register at most 3 RF URC 4 to an output. After registration, you need to use the corresponding RF URC 4
to control the outputs.
Figure 2-1 Controlling STB using RF URC 4