Echo Bear Cat SC5720B - Manual (Page 10)

6 5 INCH CHIPPER/SHREDDER/BLOWER
Section
10
7
5
9
4
2
2
8
6
3
3
1
ASSEMBLY
2
2.1 ATTACH TRAILER WHEELS 2.2 ATTACH TRAILER HITCH (NON -CE
COMPLIANT)
2.3 ATTACH CHIPPER CHUTE
1. Use a support or hoist to hold the chipper chute in place
on the chipper frame.
2. Mount the chute to the chipper housing using six 3/8 x
1" carriage bolts and nylock nuts.
1. Hold one wheel to a hub and align the wheel lug holes
with the hub lug studs.
2. Thread the lug nuts on the hub studs and tighten to 75
ft-lbs. Follow a star pattern when tightening lug nuts.
3. Repeat for the remaining wheel.
Figure 2.1, Non-CE compliant model shown
Figure 2.2, Hitch attachment locations
Figure 2.3, Wire Harness routing (CE Compliant model shown)
8
8
8
1. First, attach the hitch pole assembly (10) to the hitch
channel in the trailer deck bottom with two 3/8 x 3 1/4"
bolts (1), washers (2) and nylock nuts (3) and one 3/8
x 3" bolt (4), two washers (2) and nylock nut (3). (See
Figure 2.1.)
2. NOTE: three coated clamps (8) will be used for wiring
harness mounting and routing purposes (Figures 2.1
& 2.3). Place wiring harness in clamps before securing
the clamps in place on the bolts. See Figures 2.1 & 2.3
for clamp locations and mounting details.
3. Next, place the two hitch plates (5) over the axle and
attach to hitch pole using two 1/2 x 3 1/4" bolts (6), four
washers (7) and two centerlock nuts (9) as shown in
Figures 2.1. & 2.2.