Dimplex CASTILLO CS3540 - Manual (Page 9)

FIREPLACE INSTALLATION
1. Make sure the units MAIN ON/OFF switch is
switched OFF (refer to operating instruction
section).
2. Plug the unit into a 15Amp/120VAC outlet. If
the cord does not reach, you may use an
extension cord rated for a minimum of 1875
watts.
603
665
226
23.75
8.90
26.18
OPERATION - see Fig. 2
Three switches provide a choice of heat settings. A
switch is in the ON position when the side with the
markings on
(i.e. I, I, or II) is pushed in.
Switch 1 (I)
Controls the electricity supply to the
heater and flame effect.
Note: This switch must be in the ON
(I) position for heater to operate with
or without heat.
Switch 2 (I) Provides 600 W heat output.
Switch 3 (II) Provides 1200 W heat output with
switch 2.
1 2 3
I II II
FIG. 2
6