DoorKing 1812 Plus - Manual (Page 27)

2.2.10 Hang Up Tone
Default setting is 0.
These steps set the number that will hang-up the 1812 after the conversation is completed. The hang
up tone is used when a call from the 1812 has been forwarded to an outside number. Once the
conversation has ended, the hang up tone number should be pressed; otherwise the 1812 will remain
on the line for a period of time.
1. Press * 1 7 and enter the MASTER CODE. [ * 1 7 _ _ _ _ (beep)]
2. Enter the hang up tone number then press *. [ _ * (beep)]
3. Press 0# TOGETHER to end. [0# (beeeeeep)]
2.2.11 Call Waiting
Default setting is 1 (Call Waiting On).
These steps will turn the Call Waiting feature either ON or OFF. The call waiting feature will allow the
resident to place an outside call on hold when a visitor presses the call button on the 1812. Once
communication with the visitor is established, access can be granted or denied. If access is granted
(press the number to open the door or gate), the 1812 will automatically switch the call back to the
outside call. If the resident wants to deny access, they simply press the # key to switch back to the
outside call.
1. Press * 2 0 and enter the MASTER CODE. [ * 2 0 _ _ _ _ (beep)]
2. Press 1 * to turn Call Waiting ON, OR 0 * to turn Call Waiting OFF. [ _ * (beep)]
3. Press 0# TOGETHER to end. [0# (beeeeeep)]
2.2.12 Turn Speaker On
This command allows you to call the 1812 from a remote location and turn on the speaker at the unit
to enable two-way voice communication and will allow relay control – all tone open numbers that are
programmed (2.2.8).
1. Call the resident’s phone number. After the programmed number of rings (2.2.9) the
1812 will answer with a tone.
2. Press * 1 6 and enter the MASTER CODE. [ * 1 6 _ _ _ _ (beep)]
3. Hang up when your conversation is completed.
1812-161-E-1-10 Page 27