Dove Systems DM-624 - Manual (Page 6)

6
*Trim out of adjustment Adjust trimmers R16, R15, or R27
To change an SCR module or SSR:
1. Disconnect power from dimmer.
2. Remove five screws binding top panel to side panels and back.
3. Remove connections from the suspect SCR Module. There are six modules with two
channels in each. The module closest to the fan is channels 1 and 2.
4. Remove screws binding module to heat sink and replace module.
5. Reassemble in reverse order of disassembly.
To change the circuit card:
1. Disconnect power from dimmer.
2. Unscrew four captive screws holding circuit board panel to front panel.
3. Slide card out. Set jumpers and switches on replacement card to match.
4. Slide replacement card in until it seats into edge connector and screw down.
Users with further technical questions may call the factory at (805)541-8292. NOTE: DOVE SYS-
TEMS DIMMER PACKS USE TRADE SECRET AND PROPRIETARY CIRCUITY. FOR THIS REA-
SON, SCHEMATICS CANNOT BE RELEASED FOR THIS PRODUCT. To obtain service, pack the
unit with the original packing materials or crushed newspaper and return it, freight prepaid, to:
Dove Systems
(The repair process is expedited when you include: a note
3563 Sueldo Street Unit E describing the problem; your daytime phone number; and your
San Luis Obispo, CA 93401 return UPS shipping address.)
WARRANTY INFORMATION
The manufacturer agrees that the Dimmermaster 624 shall be free from defects in material or
workmanship from date of shipment over a period of one year. Said warranty will not apply if
equipment is used under conditions of service for which it is not specifically intended. The
manufacturer is not responsible for damage to its apparatus through improper installation,
physical damage, or poor operating practice.
If any device is found unsatisfactory under the warranty, the buyer should notify the manufac-
turer, and after receipt of shipping advice, buyer may return it directly to Dove Systems, San
Luis Obispo, CA, shipping prepaid. Such equipment will be replaced or put in proper operating
condition, free of all charges except transportation. The correction of any defects by repair or
replacement by the manufacturer shall constitute fulfillment of all obligations to the purchaser.
Manufacturer does not assume responsibility for unauthorized repairs to its apparatus, even
though defective.
Manufacturer shall not be liable for any consequential damage in case of any failure to meet the
conditions of any warranty of shipping schedule, nor will claims for labor, loss of profits,
repairs, or other expenses incidental to replacement be allowed.
No other representations, guarantees or warranties, expressed or implied, are made by the
manufacturer in connection with the manufacture and sale of its equipment. This warranty is
non-transferable and applies to the original buyer only.
Copyright Dove Systems 1994