Digi-Star Cab Control 400 - Manual (Page 5)

Operators Manual
D3674 3
Turn on the Cab Control 400
Press [On].
-
A brief and message will be displayed.
- If no signal is being received, the indicator will flash
NODATA and the scale number. Example: .
- If a signal is being received, the Cab Control 400
display will match the display on the scale.
- Pressing a key on the Cab Control 400 front panel
causes that key-press to be entered on the scale
indicator.
NOTE: To turn Cab Control 400 off, press and hold [On/Off]
until “ ” is displayed. Scale indicator cannot be
turned “On” or “Off” from the Cab Control 400.
Communicate with a Different Truck
1. Press and hold [Net/Grs] 1-1/2 seconds to enter the
“select” mode. The Cab Control 400 will display the
indicator number that is currently communicating.
2. Press [Select] again (within 3 seconds) until desired
indicator number is displayed.
NOTE: After 3 seconds, the Cab Control 400 displays the
currently selected scale.
- If a signal is being received, the Cab Control 400
display will match the display on the scale.
- If the desired scale number is not being displayed, see
“Set Up the Cab Control 400” steps 1 through 7 on
page 5.