Digi-Star NT 460 - Manual (Page 26)

Daily Data Collection
22 NT 460 User’s Manual D3840-US Rev A
DAILY DATA COLLECTION
Insuring your data is secure from theft, fire or equipment failure requires a
small effort each day to store your data on a USB drive.
Indicator Memory
When powering up the NT 460 the memory percent full is shown on the
display. The NT 460 has enough memory to store approximately 400 loads
while sampling every ten seconds and unloading one load every nine
minutes.
It is recommended to download data from the NT 460 to the USB drive
before the memory is close to full. It takes just under five minutes to
download data when the memory is 25% full and under ten minutes when
50% full.
Mid-Season Name Changes
During the season, you may wish to delete and add field names or ID
names to your scale indicator memory. This may be done in one of two
ways.
Front Panel
For a small amount of changes, edit field names and ID names using the
keypad on the front panel. See page 8 and 10 to edit field names and ID
names. See page 24 to erase accumulator memory.
Upload New Field Names, ID Names and Accumulator Using USB Drive
For a large number of changes, perform the changes on your PC using
Nutrient Tracker
TM
software and then transfer the new information to the
indicator using a USB drive.
Before doing this, transfer your existing field accumulator data (acres
and weight) from the indicator to the USB drive and onto your PC. This
keeps the proper accumulator values on partially finished fields.