Digi-Star ICP 300 - Manual (Page 8)

ICP 300 IN-CAB PRINTER
8
3.2
Connection - RDS 'Pro-Series'
(Printer cable Pt No. S/CB/167-4-006)
Depending on the product variant, connect the 9-way 'D' plug into either the
top port or the bottom port on the back of the head unit.
A connector clamp is supplied to secure the plug in position.
Product Port Used
Loadmaster 8000i / 8000iX TOP
Ceres 8000i BOTTOM
PS Artemis BOTTOM
3.3 Setup
For all RDS instruments, the default protocol settings for printer output are as
follows,
Baud Rate 4800
Data Bits 8
Stop Bits 1
Parity None
Handshake RTS
NOTE: The printer is not configurable.
'Wizard' and 'G-Wiz'
Depending on the product variant, there may be an 'ON/OFF' setting in the
Setup menu to enable printer output.
Please refer to the calibration manual for your instrument to configure printer
output.
Pro-Series, 'G-CAN' and 'ISOCAN'
These instruments have 2 serial ports configurable for devices other than
printers, such as GPS, barcode scanners etc. Depending on the software
default settings for a particular product variant, it may be necessary to re-
configure the port setting in the Setup menu to enable printer output.
Please refer to the calibration manual for your instrument to configure printer
output.