DFI LR102-B18D/B18S - Manual (Page 17)

17
2
Hardware Installation
Note:
The system board supports maximum of 4GB (for LR102-B18D/S) and
2GB (for LR102-B18M) system memory however you can install maxi-
mum of 1GB only per SODIMM socket.
Important:
When the Standby Power LED lit yellow, it indicates that there is power
on the system board. Power-off the PC then unplug the power cord prior
to installing any devices. Failure to do so will cause severe damage to
the motherboard and components.
System Memory
Important:
Electrostatic discharge (ESD) can damage your system board, processor,
disk drives, add-in boards, and other components. Perform the upgrade
instruction procedures described at an ESD workstation only. If such a
station is not available, you can provide some ESD protection by wearing
an antistatic wrist strap and attaching it to a metal part of the system
chassis. If a wrist strap is unavailable, establish and maintain contact
with the system chassis throughout any procedures requiring ESD pro-
tection.
DDR3_2
Standby
Power LED
The system board supports two DDR3 SODIMM sockets.
DDR3_1