DFI HD101-H81 - Manual (Page 21)

www.dfi .com
21
Chapter 2 Hardware Installation
Chapter 2
Rear Panel I/O Ports
The rear panel I/O ports consist of the following:
• 1 12V DC-in jack (default) or 4-pin ATX power connector (optional)
• 2 Serial COM ports
• 1 HDMI port
• 1 DVI-I port
• 2 RJ45 LAN ports
• 2 USB 2.0 ports
• 2 USB 3.0 ports
• Mic-in jack
• Line-in jack
• Line-out jack
12V DC-in (default)
DC-in
HDMI COM 1 USB 3.0
Line-out
Line-in
Mic-in
USB 2.0
DVI-I COM 2 LAN 1 LAN 2
DC-in
DC-in jack
+12V ATX Power
1 3
2 4
Ground
Ground
+12V
+12V
This jack provides maximum of 100W power and is considered a low power solution. Connect
a DC power cord to this jack. Use a power adapter with 12V DC output voltage. Using a volt-
age higher than the recommended one may fail to boot the system or cause damage to the
system board.
The 12V DC-in jack on the system board co-lays with a 4-pin ATX power connector (optional)
as the figure illustrated below.