DFI CR100-CRM - Manual (Page 66)

66
3
BIOS Setup
If AHCI or RAID is selected in the SATA Mode Selection, it will display the follow-
ing information:
Determines how SATA
controller(s) operate.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
SATA Controller(s)
SATA Mode Selection
SATA Test Mode
Agressive LPM Support
Software Feature Mask Confi guration
Serial ATA Port 0
Software Preserve
Port 0
Hot Plug
External SATA
SATA Device Type
Spin Up Device
Serial ATA Port 1
Software Preserve
Port 1
Hot Plug
External SATA
SATA Device Type
Spin Up Device
Serial ATA Port 4
Software Preserve
Port 4
Hot Plug
External SATA
Advanced
Serial ATA Port 0 to Serial ATA Port 5
These fi elds are used to confi gure the connected SATA devices.
[Enabled]
[AHCI]
[Disabled]
[Enabled]
Hitachi HDT721 (1000.
Supported
[Enabled]
[Disabled]
[Disabled]
[Hard Disk Driver]
[Disabled]
Hitachi HDS 722 (2000.
Supported
[Enabled]
[Disabled]
[Disabled]
[Hard Disk Driver]
[Disabled]
Empty
Unknown
[Enabled]
[Disabled]
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit