Chapter 4 – DFI HR908-B User Manual

Page 31

www.dfi .com

Chapter 4 BIOS Setup

Chapter 4

CPU Configuration

This section is used to configure the CPU. It will also display the detected CPU

information.

Enabled for Windows XP
and Linux (OS optimized
for Hyper-Threading
Technology) and Disabled
for other OS (OS not
optimized for
Hyper-Threading
Technology). When
Disabled only one thread
per enabled core is
enabled.

CPU Confi guration

Intel(R) Core(TM) i3-3217UE CPU @ 1.60GHz
CPU Signature
Microcode Patch
Max CPU Speed
Min CPU Speed
CPU Speed
Processor Cores
Intel HT Technology
Intel VT-X Technology
Intel SMX Technology
64-bit

L1 Data Cache
L1 Code Cache
L2 Cache
L3 Cache

Hyper-threading

Active Process Cores
Limit CPUID Maximum
Intel Virtualization Technology

Advanced

Hyper-threading

Enable this field for Windows XP and Linux which are optimized for Hyper-Threading

technology. Select disabled for other OSes not optimized for Hyper-Threading

technology. When disabled, only one thread per enabled core is enabled.

Active Process Core

Number of cores to enable in each processor package

Limit CUPID Maximum

The CPUID instruction of some newer CPUs will return a value greater than 3.

The default is Disabled because this problem does not exist in the Windows series

operating systems. If you are using an operating system other than Windows, this

problem may occur. To avoid this problem, enable this field to limit the return value

to 3 or less than 3

Intel Virtualization Technology

When this field is set to Enabled, the VMM can utilize the additional hardware

capabilities provided by Vanderpool Technology.

306a8
C
1600 MHz
800 MHz
1500 MHz
2
Supported
Supported
Not Supported
Supported

32 kB x2
32 kB x2
256 kB x2
3072 kB

[Enabled]

[All]
[Disabled]
[Disabled]



Select Screen



Select Item

Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous

Values

F3: Optimized

Defaults

ESC: Exit

SATA Configuration

This section is used to configure SATA functions.

Enable or disable Device.

SATA Controller(s)

SATA Mode Selection
SATA Test Mode

Serial ATA Port 0
Software Preserve
Serial ATA Port 1
Software Preserve
Serial ATA Port 2
Software Preserve
Serial ATA Port 3
Software Preserve

Advanced

SATA Controller(s)

This field is used to enable or disable the Serial ATA channels.

SATA Mode Selection

IDE Mode

This option configures the Serial ATA drives as Parallel ATA storage devices.

AHCI Mode

This option allows the Serial ATA devices to use AHCI (Advanced Host Controller

Interface).

RAID Mode

This option allows you to create RAID or Intel Matrix Storage configuration on Serial

ATA devices.

SATA Test Mode

This field is used to enable or disable the Serial ATA Test Mode.