DFI DS910-CD Installation Guide - Manual (Page 2)

2
Removing the Chassis Cover
1. Make sure the system and all other peripheral devices connected to it has been powered-
off.
2. Disconnect all power cords and cables.
3. The 8 mounting screws on the sides of the system are used to secure the cover to the
chassis. Remove these screws and then put them in a safe place for later use.
Mounting screw
Mounting screw
4. After removing the mounting screws, lift the cover up.
Lift the Cover Upward
5. The SODIMM socket and SATA drive bay are readily accessible after removing the chas-
sis cover.
SODIMM socket
SATA drive bay
Note:
The system comes with an aluminum sheet on the heat sink. Please do not tear off.