Danby DBC259BLP - Manual (Page 5)

FEATURES
4
FEATURES OF YOUR
BEVERAGE CENTER
1) Tempered Glass Door: Tinted for UVprotection while still
allowing for easy interior viewing.
2) Magnetic Door Gasket: Tight fitting seals retain all the
cooling power.
3) Plastic Coated Wire Bottle Shelf
4) Plastic Coated Wire Can Shelves
5) Leveling Legs
1
2
3
4
5
THE CONTROLS OF
YOUR BEVERAGE
CENTER
To start the Beverage Center, turn the temperature control to the position
corresponding to the desired cooling. The Beverage Center temperature will vary
depending on the quantity of cans stored and on the frequency with which the
door is opened.
Setting The Temperature Control:
The temperature of the Beverage Center compartment
is controlled by adjusting/setting the thermostat
control knob, located on the exterior rear wall of the
cabinet. To start the Beverage Center and achieve
maximum cooling quickly;
• Turn the temperature control knob clockwise to the
furthest ‘Max’ (maximum) setting on the wider blue
section of the graduated control dial.
• Allow the unit to run at this setting for 3-4 hours.
• When maximum cooling is achieved, turn back the
temperature control knob setting to the 10 o’clock
position on the graduated blue control dial. See Fig.
A.
• To turn off the beverage center, (no cooling) rotate
the control knob to the “O”(off) position. See Fig. B.
Fig. A Fig. B
Turn the control to the “O” (off) position to temporarily disconnect the cooling cycle. When the beverage
center is not to be used for a long period of time, disconnect the plug and leave the door partially open.
NOTE: Wait 3 to 5 minutes before restarting if operation has been interrupted.
Defrosting: Your beverage center is designed with an “Auto-Cycle” defrost system. What is Auto Cycle
defrost? The refrigerated surfaces of the fresh food compartment defrost automatically during the “off”cycle
of the cold control (thermostat). Defrost water from the fresh food compartment is disposed of automatically,
by means of being channeled onto a drip tray located on the compressor. Heat transfer from the compressor
causes the defrost water to evaporate.
OPERATING INSTRUCTIONS