Danby DBC259BLP - Manual (Page 4)

DOOR REVERSAL
INSTRUCTIONS
1) Unplug the unit from the electrical outlet (if
connected) and lay it on its back.
2) Remove the screws from the lower hinge assembly.
3) Pull the door downward to remove it from the
beverage center.
4) Remove the upper hinge pin from the top left side
of the unit and reinstall it on the top right side.
5) Remove the plastic cap from the left side of the
door frame and reinstall it on the right side of the
door frame (the previous pin location).
6) Carefully reposition the door on the unit and push
up until the top hinge pin is inserted into the top of
the door.
7) While the door remains closed, install the lower
hinge assembly.
8) Close the door and return the unit into its upright
position (wait 60 minutes before reconnecting power
to the beverage center), verify the door alignment and
proper seal against the unit.
UPPER HINGE PIN
LOWER HINGE ASSEMBLY
AND DOOR SUPPORT BRACKET
INSTALLATION INSTRUCTIONS
DO:
• Select a location with a strong, level floor.
• Allow 5 inches of space between the back of the
appliance and any adjacent wall.
• Avoid direct sunlight and heat. Direct sunlight
may affect the acrylic coating. Heat sources nearby will
cause higher electricity consumption.
DO NOT:
• Use this appliance outdoors: this appliance is
intended for household use only. Do not attempt to
operate or store this appliance outdoors.
• Build this appliance into an enclosure: this
appliance is designed for a free-standing application
only and is not intended to be “built-in”.
LOCATION
3