DFI DT122-CR Installation Guide - Manual (Page 12)

12
Important:
When inserting the riser
card, please select a
card within 175mm (as
shown on the next
picture).
Installing the PCI or PCIe x16
Expansion Card
Mounting bracket
Mounting screw
1. The PCIe x16 slot on the motherboard is used to in-
sert a TS200-1P and TS200-1E riser card.
To install the expansion card, you need to remove the
mounting bracket and the mounting screw that secure
the bracket to the chassis and then remove the brack-
et. Put the screw and the brackets in a safe place for
later use.