Daktronics CH-2024V - Manual (Page 20)

Maintenance & Troubleshooting 3-2
17 Signal Input
18 Power input for outputs 1-8 (120V)
19 Power input for driver logic and fan (120V)
20 Power input for outputs 9-16 (120V)
24 Dim option selector
In Drawing A-46539, the numbers on the digits refer to the lamp driver output connector
wired to each digit.
3.3 Digit
Segmentation
Reference Drawing: Segments, 4x7 Lamp Matrix Digit.................. Drawing A-37685
In a digit certain lamp always go on and off together. These groupings of lamps are known as
"segments". Each digit has eight segments, referred by letters A through H. Drawing A-
37685 illustrates these segments and shows which connector pin and wire color is wired to
each segment.
3.4 Schematic
Reference Drawing: Schematic, Pwr&Sig, CH-2024V .................... Drawing A-46437
Pwr&Sig Entrance Components .................... Drawing A-46545
The schematic diagram in Drawing A-46437 shows the power and signal inputs into the
display and to the lamp driver. The component numbers correspond to those shown in
Drawing A-46545.
3.5 Troubleshooting
This is a list of possible problems that may occur and their possible solutions.
Observed Problem Possible Cause
One lamp won’t light
• Burned-out lamp
• Broken wire behind digit
Digit segment won’t light
• Broken wire
• Poor contact at driver connector
• Internal driver malfunction
Entire digit won’t light
• Broken wire
• Poor contact at connector, pin 7
• Fuse blown in driver
Half the display won’t light
• Service breaker tripped
• Main fuse blown
• Poor contact at main power
connection
• P18 disconnected