Daktronics Fuelight FL-2109 Series Petroleum Price Displays - Manual (Page 23)

Control Options 17
FLD-2000 Connection to the Display (Outdoor and Indoor)
The Fuelight ™ displays may be controlled from a location inside a building or from the base
of the displays. The following subsections provide more detail on both installation types.
Outdoor Installation
This control option permits operation of the sign
from the base of the display, refer to Figure 12
for an example. The DM-100 controller is
connected to an outdoor junction box (J box)
mounted on the display pole, which routes the
signal to the sign through a 2-pair cable (in
conduit, where required).
This control option does not require the
controller to be connected to a power outlet. In
this configuration, the DM-100 controller uses
the sign as a power source.
To operate the display using this setup:
• Connect the 9-pin to 9-pin cable from the
DM-100 controller to the J box mounted
on the display pole.
Indoor Installation
This control option permits operation of
the sign from an indoor control location;
refer to Figure 13 for an example. The
hand-held controller is connected to an
indoor J box, which routes the signal to
the display through a 2-pair cable (in
conduit, where required).
To operate the display using this setup:
1. Connect the 9-pin to 9-pin cable
from the DM-100 controller to
the 9-pin J box.
2. Plug the controller’s wall pack
transformer in to a 120 VAC
outlet.
Figure 12: FLD-2000 Outdoor Connection
Figure 13: FLD-2000 Indoor Connection