D.T. Systems H2O 1810 - Manual (Page 17)

17
TESTING
To Test the Beeper:
(H
2
O 1850/1852/1853 only)
A) Press the button located on the left side of the
transmitter (Locate button). The collar should
beep any time this button is pressed.
B) Press the button on the right side of the transmitter
(Run/Point button) to activate the Run/Point Mode.
Press the button again to change to Point only
mode. In the Run/Point mode, the collar should
beep every 4-5 seconds while your dog is on the
run, and every 1-2 seconds when your dog is on
point. In the Point only mode, the collar will beep
only when your dog is on point. You can shake
the collar to simulate your dog on the run. Press
the ’Locate’ button to cancel these modes.
To Test the Vibration:
(H
2
O 1820/1822/1823 only)
A) Follow the directions for testing the Electronic
Stimulation, and press the button on the left side
of the transmitter.
B) If you press the button on the right side of the
transmitter, the unit should vibrate for 1/2 second
and then the tester should light while vibrating at
the same time.