D.T. Systems R.A.P.T. 1400 Series - Manual (Page 18)

18
SETTING THE INTENSITY LEVEL
It is very important to set the correct intensity level on
your R.A.P.T. Training System before beginning your
training sessions to provide the proper level of
stimulation without over-stimulating your dog.
1. Place the Intensity Selection dial so that the system
is set on Level 1.
2. Turn on the Collar Receiver and then fit it properly
around your dog’s neck.
3. Press the ‘Cont.’ button and check for a reaction.
Indications of your dog feeling the stimulation
include confusion on it’s face, ears perking up,
changes in tail movements, etc.
4. If there are no signs of your dog feeling the
stimulation, increase the Intensity Level in
increments of one until your dog reacts to the
stimulation.
5. At this point, increase the Intensity Level by one or
two. This should be your dog’s ideal training level.
NOTE
Some dogs may require more or less stimulation depending
upon their individual temperament and/or size.
Setting the Jump Stimulation Level:
CAUTION: To avoid accidentally stimulating your dog,
please make sure that the collar is NOT on the dog
while setting the jump level.