D.T. Systems R.A.P.T. 1400 Series - Manual (Page 16)

16
PROGRAMMING THE COLLAR
When adding an “Add-On” collar, the collar will need to
be programmed to the transmitter. If your current collar
unit is not responding to the transmitter, it may also
need to be reprogrammed to the transmitter.
1. Select the desired Collar Selecting Switch position
on the transmitter.
2. Hold the Transmitter Magnet Indicator (white dot)
directly against the Magnetic Activation Switch (small
bump) on the right side of the Collar Receiver.
3. The SmartLED light inside the Collar Receiver will
light up solid for about 1 second, followed by 6
flashes. You must keep the Transmitter next to the
Collar Receiver during this time.
4. Continue to hold the Transmitter against the Collar
Receiver until the SmartLED light stays on solid. The
Collar Receiver is now in the Code Running Mode (the
SmartLED light will stay lit for approximately 8
seconds while it is in this mode).
5. Remove the Transmitter from the Collar Receiver
and press the Rapid Access and CONT buttons
simultaneously while it is in the Code Running Mode.
6. When the SmartLED blinks 3 times, the Collar ID
is programmed and the Collar Receiver is now ON.
NOTE – Do not move the Transmitter Magnet ON/OFF
switch from the Collar Receiver Magnetic Activation
Switch until after the SmartLED stops flashing and
stays on solid or the Collar Receiver will not go into the
Code Running Mode. You must press the NICK and
CONT buttons simultaneously while the SmartLED is lit
solid.