Danby DDW399W - Manual (Page 7)

PRE-RINSE
Water Temperature: Incoming Water
(Tank Temperature)
Program Duration: 6 Minutes
Water Consumption: 3.2 liters / 0.84US/gal.
NORMAL/SANI-WASH
Water Temperature: 151°F/66°C
Program Duration: 35 Minutes
Water Consumption: 12.8 liters / 3.3US/gal.
NORMAL/ECONO
Water Temperature: Incoming Water
(Tank Temperature)
Program Duration: 35 Minutes
Water Consumption: 12.8 liters / 3.3US/gal.
SHORT/SANI-WASH
Water Temperature: 151°F/66°C
Program Duration: 23 Minutes
Water Consumption: 9.6 liters / 2.5 US/gal.
SHORT/ECONO
Water Temperature: Incoming Water
(Tank Temperature)
Program Duration: 23 Minutes
Water Consumption: 9.6 liters / 2.5 US/gal.
6
IMPORTANT
When the "Econo" feature is activated, drying time
for the dishes will be increased. The dishes dry by
a "convection" method only. To speed-up the
drying time, suggest you leave the dishwasher
door partially open after the program is complete.
This will allow humidity from within to escape.
Push the door open button and the door pops
opens to a pre-set convection dry position.
NOTE: At the beginning of each cycle, the
dishwasher always starts in the "drain" mode.
This is because the drain pump always retains a
small amount of water (in the sump) from the
previous (last) cycle. This is necessary to keep
the pump primed.
Therefore, don't be alarmed if you see a small
amount of water being pumped-out from the
drain hose prior to the start of the regular wash
cycle. (THIS IS NORMAL)
Program Summary/Selection
Using the “Econo” Feature
The "Econo" feature gives you the option of washing
dishes at "normal" incoming water tank temperature.
(usually between 130°~140°F / 54.4°~60°C)
When activated, the "Econo" feature "de-energizes"
(by-passes) the heating element.
To activate the "Econo" feature push the
"Sani/Econo" button on the control panel.
• Push button "out" the "Econo" feature is activated.
(Sani-Wash indicator light remains off)
Operating Instructions
To operate the dishwasher;
1. Attach the quick connect hose assembly to the
faucet.
2. Push the door release button to open the door.
3. Place the dishes on the dishrack and cutlery inside
the cutlery basket.
4. Fill the detergent area on inner door panel.
(approx. 7 grams)
NOTE: If using the "Pre-Rinse" cycle only, it is
not necessary to add detergent.
5. Close the door firmly.
6. Open the hot water faucet.
7. Turn the selector switch to the desired wash
program. (Pre-Rinse, Normal, Short)
8. Push the power (on/off) button.
• Push Button in = power on.
• Push Button out = power off.
The power light will illuminate indicating the
machine is receiving power.
9. The dishwasher stops automatically at the end of
the program. Both the power light and sani-wash
light will remain illuminated, until the power (on/off)
button is switched off.