Cybex 16040 Free Weight Flat Bench - Manual (Page 9)

9
Cybex Owner’s Manual
The dimensions stated in the assembly instructions of this manual include the maximum foot print (in
use) dimensions.
• Area is not in the vicinity of high humidity, such as in the vicinity of a steam room, sauna, indoor
pool or outdoors. This unit is designed to function normally in an environment with a relative humid-
ity range of 30% to 75%.
Exposure to extensive water vapor, chlorine and/or bromine could adversely affect the electronics as
well as other parts of the unit.
• Area maintains an ambient temperature range of 50° F (10° C) to 104° F (40° C) degrees.
Tools Required
• Rubber mallet
• Flat head screwdriver
Assembly Procedure
Plastic shipping foot glides are used on Cybex Strength Systems machines to protect the bottom of
machines during transportation. These foot glides must be removed before a machine is placed in
service, the shipping foot glides will cause the machine to be unstable.
CAUTION: Remove glides
To avoid serious injury or property damage, remove foot glides before placing unit in
service. If guides are not removed unit will not be stable.
REMOVE FOOT GLIDES
1. Raise the foot of the machine slightly off the floor remove foot glides. Do not install weight stack (if
applicable) until all foot glides have been removed.
2. Loosen each foot glide by striking foot glide with rubber mallet.
3. Pry off foot guide using a flat blade screwdriver.
4. Place rubber feet (supplied with machine) on each foot of the frame.
Securely anchor machine to the floor
Cybex strongly recommends to maximize stability, equipment must be secured to a solid level
surface.
WARNING: Anchoring equipment:
• Cybex is not responsible for the actual anchoring of equipment. Consult with a
professional contractor.
• Use fasteners having a minimum of 500 lbs. tensile capacity (3/8’’ grade 2 bolts or
better).
• If legs/frame does not contact surface, DO NOT pull down with anchors. Shim
any leg or frame not in contact with surface using flat washers.