Cybex 11130 Eagle Lat Pull - Manual (Page 13)

13
Cybex Owner’s Manual
6. Loosen but do not remove bottom two screws.
Screw (loosen -
do not remove)
7. Remove the top two screws securing the back shroud.
Screw
8. Slide rear shroud assembly upward and remove.
Install the weight stack
1. Note how the increment weights are installed.
2. With an assistant holding the increment weights, move the adjusting knob to 0 lbs and
remove all six increment weights (three each side.)
3. Using an external snap ring pliers, remove the upper snap ring from one of the guide rods
and carefully lower the guide rod.
Upper snap ring
Lower snap ring
Frame
Guide rod
Wave washer
4. Remove lower snap ring and wave washer from the guide rod. Repeat for the opposite guide
rod.
5. Lean guide rods outward, away from machine in order to provide the most room for installing
weight plates.
6. Slide top weight up and out of machine and carefully set it aside.
7. Wipe guide rods clean over entire length. Lubricate with light coating of medium weight
automotive engine oil.