Cybex 11130 Eagle Lat Pull - Manual (Page 12)

12
Cybex Owner’s Manual
13. Attach pulley shaft using the pivot shaft and BHSCS that was removed.
BHSCS
Pivot Shaft
Washer
Pulley Shaft
Pulley/Cable
14. Reconnect pulley/cable to pulley bracket.
15. Verify both cables are routed properly.
16. Connect the weight stack belt to the belt clamp of cam that was removed.
Set
Screws
Cam
Install rubber feet
1. Remove each (standard) cone-shaped shipping support using a 3/4” socket or wrench.
2. Cut shipping tie securing top weight.
3. Place rubber feet (supplied with machine) on each foot of the frame.
4. Lift top weight and turn the Increment Weight Adjusting Knob to select 15 lbs (three
increment weights each side.)
5. Remove the three Phillips head screws securing the top (back) shroud and carefully remove
the shroud.
Phillips Head
Screw (3)